Video Demonstration Tutorial: How to Properly Solder & Rework PCB's With Ramp, Preheat, Soak and Quality Soldering
Technical Videos for PC Board Soldering & DeSoldering
The Science Behind Successful
PCB Prototyping, Rework & Repair at the Bench
Video: How to Solder and Desolder at the Bench.
Video introduction to the low temperature
benchtop approach and process used with
Zephyrtronics Systems.
Learn how to successfully solder, desolder,
rework and repair Surface Mount and
Thru-Hole Devices as well as resistors,
glass diodes, flex circuits and ceramic
capacitors.
Critical for all techs who build prototype
PCB's or who perform rework and repair.
Video demonstrates three critical thermal
zones PCB's must undergo while being
processed at the bench.
The 4
primary ways of PCB preheating are compared with their
advantages and drawbacks for the viewer. This
video is required viewing before purchasing any
PCB Pre-heater that
may not be best suited for your own PCB
soldering and de-soldering needs.
Video details the advantages, versatility and
utilities of
adjustable PC board fixtures
over other PC Board holders. Video
spotlights the unprecedented multiple functions and
utilities of the most popular PC Board fixtures on
the planet for 20 years.
Video highlights really quick, easy process for
desoldering and removing Ball Grid Array devices and
demonstrates a
hot air rework system.
Video shows preheating, ramping, soaking and final
reflow and removal of any BGA, QFN and SMT devices.
Video
of live demonstration of soldering surface mount
devices (SMD) onto printed circuit board assemblies
(PCB) using
solder paste
instead of solder wire and a
hot air pencil in
place of a soldering iron.
How to use
LowMelt® for SMD
removal. Live video demonstration of actual
component removal at under 150°C (300°F).
No damaged chips, lifted pads or hurt to PC
Boards. No soldering irons, no hot tweezers, no
desoldering tools, just a small
preheater.
